Sequentia 48-in x 96-in Embossed White Fiberglass reinforced plastic (FRP) Wall Panel
Best way to cut this product
9
If you have electric shears for panels or fiber cement board those will easily cut frp without dust. Reciprocating saw and demolition blade also works
Was this Answer Helpful ?Draw out where you are going to make your cuts, then use a Wagner electric heat gun to heat it up along the lines where you are going to cut, and use a SHARP utility knife. You can cut out shapes and holes this way, not just straight lines. If you have to smooth the cut edges, make sure to wear a dust mask (because breathing in the microscopic particles is really bad), and use a sanding tool or Dremel tool.
Was this Answer Helpful ?Electric tin shears cuts like warm butter and you are able to cut stright lines
Was this Answer Helpful ?Score it with a scoring tool that also cut laminate. It cuts staight and doesn't cost a lot.
Was this Answer Helpful ?I used a pair of scissors, large. Worked quite well.
Was this Answer Helpful ?Electric shears. No dust or mess
Was this Answer Helpful ?Crane recommends cutting our panels using a carbine blade with a fine tooth. Please visit www.cranecomposites.com for installation instructions and technical information.
Was this Answer Helpful ?I used my rotary tool (dremel) with a cutting disk. It zipped through it like wsrm butter!
Was this Answer Helpful ?This panel cuts very easily with tin snipps
Was this Answer Helpful ?