Bernzomatic Soldering and Brazing Oxygen Torch Cylinder

Runs out way to fast

Wish the tank was bigger and had more oxygen. You definitely don't get your money worth from it at all.

Needs to be larger

These are too small, as other reviews have noted. If it burns at a 4:1 ratio, the oxygen tanks should be available in larger sizes, or bulk package for cost savings.

Oxygen cylinder is too small and overpriced

The oxygen cylinder is too small and overpriced. If using in conjuction with Mapp for brazing you can count on the oxygen to empty within 10-15 minutes of use for a nuetral flame. The brazing kit would be fine if you could get a larger oxygen cylinder and the price was lower. In reality, this kit works great for quick brazing projects on thin material. I use it to braze steel hydraulic tractor lines that have small holes rubbed through due to vibration. I first purchased the kit to braze a ...

Don't buy the oxygen bottle

I read all the reviews on how fast the oxygen depletes , and its 100% true. I used a bottle of oxygen for brazing project about 1 inch diameter and it could not provide enough heat to the sheet metal repair area to complete the job. I have a incomplete brazing job and a empty bottle of oxygen that did'nt even last 10 min. This welding set is complete waste of money. Better to buy a professional oxy acetylene rig. Don't waste your time with this its a complete joke. I would even give this a one s...

WHen is the canister empty?

Seems there is NO competition out there for the Oxygen and Mapp Gas. Is there a simple way to tell when the Oxygen Canister is low? The Full and empty seem to feel the same weight? Why can't BernOmatic come out with a larger canister?

My Beer Yeast Culture Needs O2 !!!

This is a great product for oxygenating my beer yeast starter cultures, and for adding O2 late in the fermentation of high gravity beers. Yeah, it is expensive for what you get. But you only need a few seconds of O2 and the yeast are very happy to get it! I use a 0.5 micron difusser head. One bottle is good for MANY starter cultures and/or batches of high gravity beer.

Waste of money.

New oxygen tank ended in 3 minutes of use? That must be a bad joke. Stay away from that product.

Oxygen empty during first little job???

Soldering 2 small copper pipe joins and ran out of oxygen. Absolutely no chance of recommending this product as unable to finish the smallest job and replacement cost of new Oxygen cylinder is way too much. I bet i know what response will be "Merchant Response Hello, I apologize for your experience with Bernzomatic and the inconvenience it has caused with your project. That is certainly not how our product should have performed. Our Oxygen tanks are designed for smaller projects. As the fuel bur...

Works exactly as expected

When using mapp gas and oxygen I get a much higher temperature than mapp and air plus the flame is much smaller and focused than my mapp-air torch. If you want to cut a big steel plate in half then get yourself a plasma torch: You can only stuff so much oxygen into this type of cylinder (Pressure limitiations) so don't be surprised if you have the flame turned way up and the gas runs out fast. If you want something that can deliver a hot-precise flame in a rig that you can carry with one hand th...

READ before you buy the product people!!!

The product clearly says/indicates "High-intensity flame", which mean it's burns faster (4:1 ratio) which means less burn time, common logic/sense people. If you want to do your 4 bolts nuts factory job, get a propane/Mapp rail Tanker.