The Mikiotto DC 6-60V 30A Low Voltage Cutoff Controller Disconnect Protection Module provides automated circuit management and protection for direct-current electrical installations. Featuring dual operating modes, the module allows users to long press the UP key to alternate between charging (IN) and discharging (OUT) settings. The onboard automatic relay functions to shield connected setups from both overcharge and deep discharge conditions, helping maintain safe operating parameters.
Voltage management is customized through user-defined upper (UP) and lower (dn) threshold limits. When circuit levels cross these established boundaries, the relay cuts off automatically, which significantly extends the operational lifespan of lead-acid and solar equipment. In addition to voltage cutoff settings, smart timing features provide enhanced control over power flow. Users can configure the adjustable ON time (OP), implement a delay start (dOP) variable from 0 to 999 seconds, and set a forced start (FOP) ranging from 0 to 10 seconds to safeguard against false triggering caused by temporary load surges.
Monitoring and adjustments are straightforward with the integrated LC display, which shows operational runtime and percentage values. The intuitive button interface enables users to short press the SET key to inspect parameters or long press SET to adjust configurations. For rapid intervention, the DOWN key functions as an emergency stop control that immediately disables the relay to stop power flow.
Built on a compact PCB module measuring 6.2 x 5.7 x 2 centimeters, this protective unit maintains stable performance in DC 6-60V circuits rated up to 30A. The product dimensions measure 3.66 x 3.11 x 2.13 inches with a product weight of 0.11 pounds, while the packaged product dimensions are 3.66 x 3.11 x 2.13 inches with a package weight of 0.11 pounds. It is suited for DIY power banks, caravans, boats, solar systems, and off-grid projects.
Long press the UP key to easily switch between charging IN mode and discharging OUT mode while the integrated automatic relay guards your equipment against overcharge and deep discharge
Configurable upper UP and lower dn voltage limits allow the relay to automatically cut off power when reaching set thresholds to significantly extend the operating life of solar or lead-acid setups
Integrated timer parameters include adjustable ON time OP plus delay start dOP from 0 to 999 seconds and forced start FOP from 0 to 10 seconds to prevent false triggering caused by sudden load surges
Short press the SET button to check active parameters, long press to customize settings, and use the DOWN button as an emergency stop control that immediately disables the relay
The clear onboard LC display conveniently shows running time along with percentage values while providing stable performance across DC 6-60V circuits rated at 30A
Featuring a compact 6.2 by 5.7 by 2 centimeter PCB module footprint with an assembled weight of 0.11 pounds, this board is ideal for DIY power banks, caravans, boats, and off-grid solar projects
