Mulch Stay 1 Gallons White dries Clear-ONE COAT Mulch glue

Mulch Stay: Strongest Mulch Glue, Stops Washout, One Coat Advantage Mulch Stay Mulch Glue is the strongest mulch glue on the market, designed to lock down and preserve mulch, rubber mulch, stone, pea gravel, and pine straw so it STAYS in place, will not wash or blow away, and looks new longer (like the day you put it down). And with a ONE COAT COVERAGE advantage, it covers the same square footage for around half the cost of others. For DIY, homeowners, landscapers, and professional users, with Mulch Stay, landscapes stay clean, defined, and looking new longer. HOW TO USE INSTRUCTIONS: IMPORTANT NOTES ON COLOR & APPEARANCE (ESPECIALLY ROCK/STONE). IN EVERY SITUATION, ALWAYS TEST IN INCONSPICUOUS AREA FIRST TO ENSURE YOU ARE SATISFIED WITH RESULTS! MAY ENHANCE SURFACE COLORS WHICH MAY AMPLIFY OR LOOK WET AFTER DRYING. SHAKE WELL. READY TO USE. ADD TO TANK SPRAYER. NEW, FRESH MULCH IS OFTEN WET & DIRTY. FOR NEW MULCH, RINSE WITH HOSE FIRST. LET DRY FOR 48 HOURS OR UNTIL COMPLETELY DRY. BLOW OFF ANY DEBRIS. COMPRESS MULCH INTO PLACE BEFORE GLUE APPLICATION. ONLY APPLY IF TEMPERATURES REMAIN ABOVE 50° F BEFORE AND AFTER INSTALLATION. APPLY IN A SLOW, EVEN, SATURATING COAT. TYPICAL ONE COAT COVERATE RATE IS 150 SQUARE FEET FOR MULCH & 400 SQUARE FEET FOR PINE STRAW. IF USING TWO COATS, APPLY SECOND COAT AFTER FIRST COAT IS COMPLETELY DRY. ONCE SPRAYED, IT MAY HAVE A WHITE / BLUE TINT BEFORE DRYING. THIS SHOWS WHERE YOU HAVE APPLIED. LET DRY AT LEAST 24 HOURS OR FULLY DRY FOR THE TINT TO BECOME CLEAR. WAIT 24 HOURS OR UNTIL COMPLETELY DRY TO CHECK APPEARANCE. AVOID SPRAYING DIRECTLY ONTO PLANTS OR TREES. CLEAN ALL APPLICATION EQUIPMENT IMMEDIATELY AFTER USE TO PREVENT DRY GLUE DAMAGE.