IDEAL 1/4-in x 7-1/2-in Hex Nut Driver

Hollow shaft makes this one better

My initial impression is good. I bought primarily for the depth of the 11/32 so I could remove nuts from studs. Most multi nutdrivers have no depth and will work on bolt heads or shallow nuts only. It does have a hex shaft so that you could perhaps use a small wrench as a cheater to break the nut loose if needed. Feels solid but I just got it so can't testify to longevity as I've only used it a few times as of this review.

Nice anti roll handle and good socket depth.

Very nice if you get one without problems. The anti roll handle design is very nice and comfortable. The approximate socket depth is about 1 inch on the small sockets. The first multi nut driver was returned because it had multiple hair line cracks in the handle when LED light shines through it. It was covered in dust and probably fell off the store hook or was dropped on the store floor. The other brand new multi nut driver tool's handle is fine with no hairline cracks. A couple of its sockets...

Lots of screws to be loosened or tightened with 1

Needed a tool just like this for different types of screws!

multi bit

I own this and the Klien and they each have a place.

Shaft doesn't stay in handle well. Weak b bearing

Like the handle, fit & size. Even has the 11/32 (green strip) w/deep socket, needed for 8/32 screw "nuts" common in electrical trade without buying the bulkier & heavier style brands in order to get that 11/32 size! Problem! The shaft center pin bearing spring is to week. Often when pulling it out of your tool pouch, you just end up with the handle only in your hand!! Daa! Shaft w/ drivers are still down in your pouch!! That's a pain in the butt Problem!!! Fix it please!