Grizzly Cast iron Router Table

Heavy duty

Very well made and heavy duty. Sliding table is awesome. I only have really a couple disappointments with what I’ve found so far and that is that there isn’t a measurement scale printed on the working surface for fence movements for a quick visual adjustment such as what Bosch does on their tables. The other is no above table router adjustment hole. If it would have had that I would have given 5 stars.

Great router table

A very nice router table but there are a few things I would change. The cast iron table locks simply do not work. I had to remove the lock because once in the lock position you could not longer release the lock to lower the table, basically leaving the table stuck in the upright position. The cast iron table is also very heavy and the only lift point is a sharp metal edge which requires gloves to raise the table. I took a piece of 1/2" pex tubing and cut a slot down the full length of the pex pi...

Well-built but I did not think ahead

Wish I could use an insert to raise and lower the router.

Not impressed

Happy with the idea. The plastic slides that will quickly wear out for the sliding table would better as bearings races. The 7 piece fence, dust collection deal makes it near impossible to square the "fence??" What am I squaring to, as there is nothing to determine this. Really love machines that have no "0" setting so it takes forever to set up

Installation of the router 1/2 star

Had this table for one week this Router table needs some re-engineering. Initial installation of the router to the router table would be easy if they simply gave you another insert with a quarter inch hole so you could put it into your router to center your router to the center of the hole on the table metal insert ..The Router base clips are too deep to hold a thin router base. The bolts to tilt the clip for thinner bases are too short if the bolt goes into the groove on the underside of the ta...

Poor Quality Fence Degrades Potential for Success

Bought a week ago. Setup wasn't very complicated but the parts were stamped with L&R incorrectly so they wouldn't line up until I ignored the markings. Can't get fence straight for the life of me, the adjustment knows don't move the wing true or consistent. Lastly the table doesn't work well with my Bosch router so I'm using an old porter cable one. Other than all that, the table seems pretty decent but the fence makes or breaks ya.