Dremel Tungsten carbide 1/8-in Multipurpose Bit Accessory

4 uses with no damage

So far so good

Great bit, highly recommended!

I bought this (along with a new Dremel) to fix the door latch on a few doors in the house. It worked super well and I wish I had bought it sooner. Highly recommended!

9903HP Tungsten Carbide Carving Bit

I purchased this product about a week ago. I purchased this product because I had a project that 1/4" steel plate and it worked flawlessly. I used it with the Dremel 565 Multi-Purpose Cutting kit and it really helped keep it stable for precision grinding. No negatives to say.

Works great on steel plate

Used this to make some adjustments to a deadbolt strikeplate to basically make the hole in the strike plate slightly larger. Worked great cutting away the steel.

Light work on light metal

I purchased to grind off a little bit off a strike plate. Very sharp. Like cutting through butter.

Works

Ground a broken M8 tap out my truck bed. Started with a 5/32" grinding stone to slowly maker a center depression so the carbide did not wander. Ran the Dremel at max RPM and periodically added 3 in 1 oil. Broke through to the bottom of the tap, and then enlarged the hole until the center web of the tap was gone. Thread was still intact, finished cutting with a new sharp tap

Like it but it was too sharp to remove epoxy.

[This review was collected as part of a promotion.] Dremel Max Life 9903HP 1/8" (3.2mm) Tungsten Carbide Carving Bit Tungsten Carbide Carving Bit was the best for removing epoxy. While did it not work as well as the 561 MultiPurpose Cutting Bit. It was able to remove the epoxy well. The bit was too sharp and I worried it would change the internal diameter of the golf shaft.