Dial 5-in x 32.75-in x 2-in Steel Evaporative Cooler Leg kit

Making customers feel secure

Although we had to send the first one back due to damage and the second one was also dented, they made things right and had accountability, which goes a long way. Everyone was polite and helpful.

Well made cooler leg kit

Mostly, the kit was good. They really need to use a little longer screws. Even a 1/4” longer would work

Look some where else

The brackets are ok at best, but the mounting hardware is worthless! If you use buy 1/4-20 x 1 bolts and 1/2 to 3/4 in washers to bolt it on and pre drill everything you try to put through the case of the cooler.

UR PRODUCTS ARE OPEN AT THE STORE AND NOT CHECKED

well this item fine .but i had to return it because not knowing if the swamp cooler was going to be bought. SO THEY BOUGHT THE COOLER! I PURCHASED THIS ITEM AGAIN. I MADE SURE I DID NOT BUY THE OPEN ONE! WELL I MUST HAVE BECAUSE I NEVER GOT THE SHORT LEG ONES OR THE BOLTS TO THEM. ONLY THE TWO LONG LEGS. NOT HAPPY!!!!!!!!!!! ALSO THE COOLER IS VERY LOW QUALITY . I HAD TO DRILL OUT THE ELECTRICAL KNOCK OUT. FRAME IS WEAK ALSO.NOT WORTH IT !!!!!!!!!!!!!!!!!!1 I CANT TAKE IT DOWN AND GIVE IT BACK ,...

Just what I needed for a new evap cooler

The round corner leg kit does its job, but could use a simple improvement or two. The area in Colorado that I live in is known for high winds with gusts of up to 60-70 mph. I thought the leg design needed a little beefing up since I did not want risk the $400.00 cooler (plus another $300.00 in installation parts) blowing off the roof and go crashing to the ground. I added large 1-1/4 inch diameter "fender" washers behind both the bolt heads and nuts that connect the legs to the feet. Because t...