BORA Ngx Guide Rail

not a precision guide system

Well packaged, thats about the only positive thing I can say. Unboxed and placed saw plate into guide rail - way too much slop… almost a 32nd of movement between the aluminum extrusion and the plastic guide/saw plate. The plastic guide rides in the slots on the aluminum… the aluminum slots are over a 64th out of parallel. Didnt even bother to check straightness of the aluminum rail or try to screw the extensions together. Boxed it back up and going for a return. This would probably help you...

Almost Useful

Tried it out once. Plastic saw slide wouldn't fit into grooves without filing down edges. Would not slide smoothly. At joint it would catch until filed down metal slots. Clamps would only slide so far as molded too big. Needs a lot of post production work to be useful after purchase. Nice idea but no quality control.

Not a straight edge

You would think this would be good as a straight edge. But mine is kind of bowed in the middle. I don't think I can trust it. Yet another useless tool to throw in a corner, to collect dust.

Check with Bora to see if your saw will fit

I have a Ryobi 6 1/2 inch cordless Circular saw and I did well getting it sit on the sled until I tried to put a battery in. There’s nowhere to hook the sled on the back end of the saw with the battery in place. The tracking clamps seem to work well as far as holding in position that I was unable to actually use it because my saw didn’t fit. I didn’t know that when the Saul was mounted on the sled without the battery there was a lot of play to the right and left with the sled raising about a qua...

Easy alternative to a table saw

Simply a very simple and safe alternative to a table saw.