SteelTek DIY Custom Structural Pipe and Fittings Ridge Stair Railing

ANGLED STAIR RAILING SECTION INSTRUCTIONS 1.       Measure the available space the project fits in; for each Swivel Base, subtract 3.25-in from the total measurement. This will provide the pipe length needed for installation. 2.       Cut the pipe to the length measured in Step 1. 3.       Place the Swivel Bases on each end of the pipe and test-fit the railing and make any necessary adjustments. 4.       Mark where the Swivel Bases will be installed and pre-drill the holes. 5.       Install the Swivel Bases onto the pipe, ensuring the set screws face the same direction for all rail lengths. 6.       Install the assembled rail using screws or appropriate fasteners. STRAIGHT STAIR RAILING SECTION INSTRUCTIONS 1.       Measure the available space the project fits in; for each Swivel Base, subtract 0.15-in from the total measurement. This will provide the pipe length needed for installation. 2.       Cut the pipe to the length measured in Step 1. 3.       Place the Flanges on each end of the pipe and test-fit the railing and make any necessary adjustments. 4.       Mark where the Flanges will be installed and pre-drill the holes. 5.       Install the Flanges onto the pipe, ensuring the set screws face the same direction for all rail lengths. 6.       Install the assembled rail using screws or appropriate fasteners.