Ratings & Reviews for Froth-Pak Low GWP 200 Spray gun Indoor/Outdoor Spray Foam Insulation Kit

buyer beware

i have used spray foam in the past from a different brand and am familiar with all of the ins and outs. This product is garbage! It did not mix together despite my following all instructions and having tanks at the ideal temperatures. Some sections hardened and peeled away from the plywood and other sections evaporated and left a super sticky mess. What a waste.

Everyone was very friendly and quick

It's okay...

Didn't go as far as i wanted. One pass did the first layer of 100gt of floor joist ends. 2nd kit started failing right away. Kept blowing off the nozzles off. Then, wouldn't dispense the last 1/4 of the tanks. So... not overall satisfied.

Worked great

There are a lot of bad reviews so I felt obligated to write one after a good experience. The product worked as advertised. I will say that I was very cautious after reading the bad reviews so I sat down with the manual and read the entire thing. It worked really well for me and only had one mishap which was user error...just make sure you clean the gun out when swapping tips and when putting the new tip on make sure it goes all the way back and clicks into place.

Stay away!!!

Bought 2 kits for a project after researching and watching videos. Set the system up, tanks up to temp and hooked everything up. About 20 seconds in had liquid running down the arm of my tyvek suit. Stopped and checked gun. Replaced nozzle and started again. Got worse and started squirting out the handle and back side of the gun all over me and everything around me. Absolute mess. Had to shut it down. Brown urethane all over the place. Cleaned up and restarted with the second kit. Worked a...

be quick because it can harden up inside the gun

it was easy to use

Coverage is less than half of the stated amount.

It’s a very effective sealant, but it was not the coverage I expected. Whatever sq footage of coverage you think you need, double it and it will still fall a bit short of your estimation.

If you get on your skin WD-40 will help remove it

Used this for many year for Styrofoam glue/ bonding for big foam sculpture .

Bad invest

Item would have been good investment if product materials would have sealed correctly. The red tank kept leaking at fitting no matter how tight I made it . The nozzle would not latch properly causing it to leak as well. End up only doing 1/3 of house where it could have done whole house.

The gun is junk. Just be careful

Ok

It's very expensive for the of foam it brin

The product is good, easy to use, but the price is very high because what the tanks have of foam is very little for the price of more than 400 dollars, including taxes.

Great Kit

I am a general contractor. The insulation companies won't setup their foam gun for anything under $2,500. I needed one wall of the home completely sealed due to the elements trying to creep in. This stuff did the trick and did it very well. Highly recommend this kit for small jobs.

Cures quickly

It did the job as advertised. I would recommend putting the tanks on a furniture dolly for roll around jobs because the tanks can get cumbersome moving every few feet. The solution cures incredibly fast. Spray every 10-15 seconds or risk having to changeout the nozzle often, especially with the fan nozzle.