I do not have a on and off switch. I took tags off and put out and no light. But yet I have a sticker saying Do not take cover off on/off switch. Ther
2
WRONG!!!! You must remove the solar panel (4 screws) and remove the cardboard from the positive battery post. Pull the green cardboard only tears it.
Was this Answer Helpful ?Hi, Thank you for contacting us. The switch should be under the housing of the unit. For optimum performance, it is best to install the solar light in full sunlight and charge for 10-12 hours of full and direct sunlight with the switch in the“ON” position. Note: the battery of solar flood light CANNOT be charged when placing the switch in the OFF position. Allow the light to run at least 8-12 complete charging and discharging cycles to reach battery’s maximum capacity. In case you need any further assistance please be free to contact us on below contact information. Email Address: customerservice@jiaweitech.com Toll Free Number: +1(866) 897 2098 Regards, Jiawei Team
Was this Answer Helpful ?