Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Install a Gable-Mounted Power Vent

Exhaust heat and humidity from your home's attic, even on calm days with no wind, simply by installing a gable-mounted power vent.

install a gable-mounted power vent

Tools & Materials

Materials

Product costs, availability and item numbers may vary online or by market.

Missing anything? Shop Online

Calculate Your Eave Vent Size

Power ventilators for gable-mounted vents come in a number of sizes and are rated by cubic feet of air moved per minute (CFM).

Determine your attic's square footage. Multiply this number by .7 to give you the minimum CFM required for your power ventilator.

Example: An attic with 1,500 square feet x .7 = 1,050 CFM

Make sure you also have adequate air intake. A rule of thumb: 1 square foot of intake for every 300 CFM of ventilator.

Example: 1,170 CFM ventilator / 300 = 3.9 square feet of intake ventilation

This is the minimum intake required.

Caution

For wiring, always use a qualified electrician who is familiar with local and national electrical codes.

Gable-Mounted Power Vent Installation

Install a Gable Mounted Power Vent

Make sure all factory-installed bolts are securely tightened. There are many louver styles available. These instructions will apply to all types of gable louvers commonly used. These instructions assume a rectangular louver with a stationary vane.

Step 1

Measure the dimensions of the existing louvers from inside the attic.

Step 2

Cut a piece of plywood the right size to seal off this area. You want to block all airflow except for the vent you'll be installing.

Step 3

Place the fan on the board in the center and trace around it.

Step 4

Cut out the area for the fan using a jigsaw or coping saw.

Step 5

Attach the fan over the hole on the board, and secure the brackets with screws.

Step 6

Mount this entire assembly over the existing louvers.

Step 7

Attach the thermostat close to the airflow drawn by the fan or let it hang free.

Step 8

Set the thermostat at 90ºF degrees. The power ventilator will automatically start at approximately 102ºF degrees. When the temperature drops to 90ºF degrees, the fan will automatically shut off. You can test this with a work light or hair dryer.