Franklin Brass 3-3/4-in Black Wall protector Door Stop

Great Brushed Nickel with Nice Stop and Threads!!!

Excellent Quality and plenty of threads seamless mounting. The rubber cushion is much better than others I have tried previously. Would buy this again!

4-in Satin Nickel Wall Protector Door Stop

This is a very well finished door stop. It is very solid. The screw in is large in diameter and fairly long, so it will not move in the base molding. It will require a pilot hole in the base molding to keep the molding from splitting. Note that this is a "no give" stop as opposed to the spring stoops commonly seen.

Well made door stop

This is a well made door stop. Super strong, cushion tip well made and should last a long time. Screw base firmly attached for a tight installation. Surface finish is nice satin nickel.

Nice, stylist door stop.

Nice design and was very easy to install. Would have been nice to have some flats to get a wrench on, but it went on well by hand. Replaced a builder grade one in our bathroom.

Door stopper

I have needed one of these for a few months. It was easy to install and my door no longer hits the wall. I would by this one again if needed, but I think it's going to outlast me.

Simple and convenient to install

Straightforward installation and does the job as expected. I was happy with how it held up against my heavy front door without causing any additional damage.

Nice heavy duty and great finish .

I received this as a promotion. I was pleasantly surprised at the quality of this door stop . In past with children and now with grandchildren these stops would take a beating , snap or work their way back out . This is a solid well made stop.

Satin nickel door stop

This product was used to replace a product I had in one of my bedrooms, so So the hole is already drilled out I just had to remove the old one with the Phillips head screwdriver and then take the rubber. Stop off the new one and screw it into the same hole. The whole process took about five minutes. It looks good and it looks well-made

Great for what it is supposed to do.

This is a robust door stop. It seems to be made of one piece. Be aware that it is rigid and if pushed hard enough. It could puncture a hole through your door. It can also break your baseboard if stepped on. The advantage is that it is super strong. You will need to pre-drill your baseboard. Also be careful twisting the doorstop, particularly if you are using a wrench so you do not scratch it. If you are just doing a few of these you are okay. If you are doing dozens of them at a time, make sure ...