Flashwind 1.5-Sone 110 CFM White Bathroom Ventilator Fan With LED Light and 3CCT

Quiet fan. Slightly flimsy.

The fan is quiet and fairly easy to install as a retrofit. The only drawback is the installation feel pretty flimsy. It’s set up like a retrofit outlet box with plastic tabs that flip over on screws. The entire housing is plastic.

Very quiet!

This replaced a smaller fan that I had in the bathroom and this seems to move a lot more air a lot quieter than the previous one. Odor is gone in minutes. Very easy to install all the pieces in the box were intuitive. There were far fewer pieces than the previous fan I installed as well.

Not for retrofit, good for new construction

This unit would be great for new construction, but not ideal for a retrofit. The vent diameter is 4” compared to the 3” used in standard homes around here, so a step down is necessary. It also extends past the lip of the trim, so to make it fit into the original hole, you have to cut out excess Sheetrock to make it fit. When wiring, the neutral wire is colored black instead of white, but I was labeled. Could be confusing to someone not familiar with electrical. Ground wire was also not attached ...

Quiet, Easy Upgrade for a Small Guest Bathroom

Installed this in my small downstairs guest bathroom during an update/remodel, and it went in with no problems. After almost 20 years, the original exhaust fan finally died, so I chose this one after reading through the specs. It arrived nicely packaged, and the instructions were clear and easy to understand. I also did not have to replace the original wall switch—this fan worked exactly as it should with the existing switch. This bathroom has a single shower only, and the fan removes mirror f...

Works well

This exhaust fan works great and does exactly what we would need it to do. It was not very hard to install and looks great. I really feel like it helps the bathroom steam. Would recommend. 

Quality and easy to install

This is a very thought out quality easy to install basic bathroom fan. I really like that it’s all plastic because so many of them I’ve dealt with get rusty being in the bathroom environment. I really like it’s sleek hidden look for a basic fan. I don’t want anything to really stand out. Installation was easy. The securing mechanism is awesome. It tightens right up to the drywall there’s plenty of room to make the electrical connections, which is always a huge plus for me. All in all, I really ...

Very powerful and great looking bathroom exhaust fan.

This fan was easy to install and looks great! The fan is very powerful, moving move than enough air in my bathroom. It is also very quiet for how power it is. I replaced an old fan, and this unit was basically ready to go out of the box. It was plug and play right into my existing setup. I highly recommend this fan.

Upon installation showers are no longer foggy

Design of this vent fan is sleek function as intended ,its perfectly sized for just about any space that a vent fan is required can’t even hear it running in the room but it surely gets the job done no more foggy showers and its durable .

Easy to install and quiet!

The bathroom fan was very well built, easy to install, and fairly quiet overall. I loved the pop-out tabs on the sides, which made it very easy to fasten straight to the wooden ceiling I was installing in with no additional supports needed. The fan grate is also very easy to install and remove for cleaning and maintenance.

Good fan if you’re on a budget

I installed this ventilator fan in my basement bathroom. I am venting directly out the wall a short distance using 4” rigid ducting. Doesn’t make a ton of noise, pretty quiet for 80cfm. No sign of imbalance in blade assembly, and has an interesting fully molded plastic design instead of typical metal. The install for “Embedded” as they call in the instructions was OK. Do not cut the opening to the 8.5”x8.5” they have listed in the diagram. Measure the housing below the flange and go from there, ...