Inteplast Group Building Products 0.25 T x 0.9375-in W x 96-in L Polystyrene Outside Corner Guard

corner wall panel moulding

Very nice touch to my bathroom wall. really accents the over all theme of the room.

Corner Moulding

I’ve used this to trim out my stairway. It works very well and so easy to use. I also have used the white in this same material in the kitchen and bath.

Chips easily

It worked for what I needed it for (covering a corner that had sharp metal edges) but the veneer chips off easily and starts to be noticeable within a week or two.

Stain Match = Varathane Cognac 1/4" birch veneer

Stain Match = Varathane Cognac 1/4" birch veneer We are using 1/4" birch veneer plywood from Lowes to use as wainscot backing and found the Varathane Cognac to be the best match to this poly trim. Varathane Red Oak was very close as well on the Birch. We tested on the oak, maple, and birch veneer 1/4" plywoods, both sides, with Minwax stain pre-stain and without and 12 different stains. Insanely spent around $300-$350 to do all the testing. Good luck with your project.

Trim

Used several types of this trim, easy to use and nail, wish I knew a better way to cut angles but product is great

Very poor quality finish.

Used glue to apply the molding, and held it in place with 3M masking tape while the glue cured. The masking tape pulled the paper-like finish off the molding. The results would have been better if I had used pre-finished wood molding. This simple project turned into a complete disaster. Now I have to remove 24 feet of expensive trash molding and glue, and do the job over again with real wood molding. This product is nothing more than trash.

looks nice

just the right edging to go around the walkway between the front living room and the kitchen...