FREE SHIPPING ON QUALIFYING ORDERS $49 OR MORE
Spray frosting gives you the look of decorative etched glass without harsh chemicals. When you're ready for a new look, the frosted finish scrapes off with ease.
Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown.
Missing anything? Shop Online
Remove the door from its hinges and lay it on a work surface in a well-ventilated area with the side to be frosted facing up. Thoroughly clean the glass.
For a clear border of 1 inch around the frosted area, place 1-in painter's tape around the outside edges of each pane with one tape edge against the wood muntins separating the panes.
Tape the individual muntins and mask off the frame of the door to protect it from overspray.
Follow the label directions to apply an even coat of frosting on each pane. Let dry and apply a second coat. Even if you have to spray a third coat, apply the lightest possible amount with each coat.
After the last coat dries for at least five minutes, remove the tape from the glass, muntins, and the door frame.
Finished frosted glass-panel door.
Place the glass tabletop on a work surface in a well-ventilated area with the side to be frosted facing up. (We frosted the underside of the tabletop to avoid scratching the spray finish off the glass.) Clean the glass.
Lay strips of 2-in tape around each edge of the table with the tape edge flush with the edges of the glass. Inside the taped boundaries, lay strips of 1-in tape with the edges just touching the pieces of 2-in tape. Inside the area of these two taped rectangles or squares, lay a strip of 1-in tape on each side just touching the middle strips of 1-in tape. Trim the tape ends to form 90-degree corners that don't overlap the middle tape strips. Remove the center strips on all four sides.
Protect the center of the glass by covering it with kraft paper and taping it in place. Also, protect the edges of the glass by wrapping them with tape.
Spray two coats of frosting according to the label directions. After the final coat dries, remove the tape and kraft paper.