Square D (3-Pack) 60 Amp Single phase (120V/240V) Non-fusible Outdoor General-duty Enclosed Molded Case Switch Disconnect

worst knock outs I have ever dealt with.

I couldn't remove the knockouts to save my life. I might have been unlucky with one they over welded/ didn't cut through enough. Either way the box is damaged now and I have to get another one

The only one I install!

I am a retired commercial electrician and these are the very best inside and out. I have used many of these on AC air handlers, AC condensers units, water heater systems and other things like industrial motors. They are sturdy thick metal, lugs are strong, and easy to install. At Lowe's these cost lest than many of those lousy pull out contactors that I would not use. I just installed these at my daughter's house for a water heater, the other water heater will get one soon, and her Pottery Ki...

Easy Knockouts

I used this for my mini split install on the side of my garage. Easy install and easy knockouts.

Square D, the original

The ORIGINAL shutoff swith, Square D invented the device and is still the industry leader and at this price an outstanding value

Well built. Square D is top notch!

Works great! Just what I needed. You can’t go wrong with Square D.

Square D 60 amp single phase disconnect

I received a text message with the very easy instructions. I arrived at the front door and retrieved my package with ease. Would definitely do this again and refer my friends and family.

Good price - poor product

Online description states "molded case." Box label states "molded case." Included instructions state "nonmetallic." But the QO200TRCP in my box was a metallic enclosure with a poor design: The nonremovable door does not open all the way (perpendicular to the enclosure), making it difficult to see, much less access, the shutoff switch which is mounted too high inside the enclosure. Worse yet, the door does not lock open, so you have to waste a hand holding the door open to access the switch ...

Difficult to attach tightly to a wall

The cover has a lip on the back that makes it very difficult to attach the box tightly to a wall. You have to remove the cover to attach the box, but then (if the box is tight to the wall), you can't get the cover on. POOR DESIGN and so AVOID.

This is a switch, not a breaker

This was an exact replacement.