Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Used frequently for kitchen and shop cabinets, a French cleat is an easy, yet strong way to hang large items on the wall.

Hanging With Cleats

We've used cleats several times for varying projects, including headboards, a window cornice, a TV cabinet and a window box.

This type of cleat consists of two parts, each with a 45-degree bevel cut along the length of an edge. It’s a snap to create on a table saw; simply rip a board near its center at 45 degrees. One half of the board will be attached to the wall, the other half either is used as the back rail of the project, or is attached to the back of the project.

If it isn’t used as the back rail, you’ll need to attach an offset board the same thickness as the cleat near the bottom of the project, as is the case with the headboards mentioned above.

Positioning the cleats is key, and confuses some people. For the cleat attached to the wall, position the narrow face of the cleat against the wall. The thin edge (point) of the bevel should be away from the wall and facing up. This creates a pocket for the beveled edge of the project cleat or back rail. For the project cleat or back rail, position the narrow face of the cleat against the back of the project with the thin edge of the bevel away from the back of the project and facing down. Think of the two cleats as puzzle pieces designed to fit together.

Attach the wall cleat to the wall using appropriate fasteners for your wall type and use a level to make sure the cleat is aligned properly. On a typical wall with drywall and wood framing, attach the cleat to the wall studs using wood screws. For example, on a cleat cut from a 1x board (3/4-inch thick) and 5/8-inch thick drywall, use a 3-inch wood screw. You can countersink the screws as well.

The project cleat or back rail needs to be securely attached to the project as well. We use a couple of methods on the projects above, but generally glue and screws.

You can then place the project on the wall cleat, making sure the project cleat is fully seated into the wall cleat.

Chris HillChris Hill
SPC Connect





Read more Woodworkers Blogs.

Tools, products, materials, techniques, building codes and local regulations change; therefore, Lowe's assumes no liability for omissions, errors or the outcome of any project. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed professional if in doubt about any procedures. Please read our terms of use.

Article Contents