Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Tablet Stand

Brought to you by Lowe's Creative Ideas

Put your electronic tablet or e-reader to work on a make-it-yourself stand you can build for less than $20.

Tablet stand

Project Overview

Skill Level

Beginner

Estimated Time

A few hours

Estimated Cost

$$$$$

Tools & Materials

Tools

  • Miter box and back saw
  • Cordless drill
  • 3/16-in drill bit
  • Painter’s tape
  • Wood glue
  • 180-grit sanding sponge
  • Paintbrush

Materials

  • 5/8-in x 36-in square dowel, #27695
  • 2 - 1/2-in x 36-in square dowels, #27692
  • 5mm x 24mm nickel-plated shelf pins, #36755
  • Rust-Oleum gray aerosol primer
  • Valspar Signature, Can’t Miss Lime (#6011-10)

Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown.

Missing anything? Shop Online

Project Resources

Instructions

Frames

Step 1

Cut 5/8-inch square dowels for the legs (A) and back legs (B) (Project Diagram). You can use oak or poplar stained your favorite color. We used poplar, which we’ll paint later. Cut 1/2-inch square dowels to length for the rails (C). Sand the wood parts with a 180-grit sanding sponge.

Step 2

Assemble the frame with spacers and clamps.

Cut four pieces of 1/2-inch dowel 1-1/2 inches long to use as spacers. Assemble the frame using clamps to hold the parts together while the glue dries (Photo 1). Assemble the leg frame using the same process. The 1/2-inch dowels sit flush with the back of the 5/8-inch dowels. This recess on the front side keeps the tablet from shifting on the stand.

Step 3

Drill two 3/16-inch holes 1/4-inch deep for the shelf pins. The 5mm pins are slightly larger than the 3/16-inch holes for a snug fit with no adhesive.

Step 4

Hold the assemblies together with tape while the glue dries.

Tape the back frame to the front while the glue dries (Photo 2).

Step 5

Apply a primer and paint following the manufacturer’s instructions. When the final coat dries, gently tap the pins into the holder.