Lowe's Home Improvement
FREE PARCEL SHIPPING on Qualifying Orders

Make a Lightbulb Snowman

Brought to you by Lowe's Creative Ideas

Turn a plain lightbulb into a cheery snowman ornament to hang from your Christmas tree.

 Snowman ornament made from a lightbulb

Project Overview

Skill Level

Beginner

Estimated Time

A few hours

Estimated Cost

$$$$$

Tools and Materials

Tools

  • Scissors
  • Tape
  • Needle
  • Utility knife
  • Wire, string, or cable tie

Materials

  • 2-in x 8-in red oak iron-on edging, #16547
  • Microfiber strip mop refill, #367394
  • 25-pack plastic standard wire connector, #49645
  • 150-watt soft white decorative incandescent lightbulb, #91755, or white round ornament
  • Spray paint, white
  • Sharpie black permanent fine marker, #155448

Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown. Availability varies by market for lumber species and sizes.

Missing anything? Shop Online

Instructions

Step 1

Working in a well-ventilated area, spray-paint the lightbulb white. It's fine to get paint on the screw base -- it will be covered.

Step 2

To make the snowman's top hat, measure the diameter of the screw base, and then cut a circle of veneer about an inch larger in diameter. If you're using an ornament, cut a circle about 2-1/2 inches in diameter. Adjust the size if the ornament is much larger or smaller. Use a utility knife to cut a hole in the center of the veneer circle large enough to fit around the screw base.

Step 3

Cut a strip of veneer that's 1-1/2 inches high and long enough to wrap around the screw base of the ornament (about 5-1/2 inches). Place the circle from Step 2 on the screw base and wrap the veneer strip into a ring around the base; check that the hat looks right. Remove and color both pieces using a black marker.

Step 4

When dry, glue the ring of veneer onto the lightbulb screw base as shown in the picture. Glue the wrapped veneer circle on top to form the hat. Use wire, string, or a cable tie to hold the veneer until it dries.

Step 5

Glue one wire connector to the center of the ornament for a nose. Draw two black eyes on the lightbulb using a black marker.

Step 6

Cut one strip from the mop, approximately 9 inches in length. Wrap around the base of the bulb to form a scarf and glue, as shown in the photo. Let dry, then hang!