Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Entry Wall Hangers

Brought to you by Lowe's Creative Ideas

Hang anything on any wall with these easy, colorful, and super-adaptable hangers made from decorative millwork.

Painted wall hangers

Project Overview

Skill Level

Beginner

Estimated Time

A few hours

Estimated Cost

$$$$$

Tools & Materials

Tools

  • Drill and bit set
  • Pliers
  • 6-in or 8-in adjustable wrench
  • Electronic stud finder
  • Painter’s tape

Materials

  • 4-in maple foot, #295979
  • 2-1/2-in bun foot, #236112
  • 1-7/8-in bun foot, #236119
  • 6-in table leg, #43511
  • 5/16-in x 3-in dowel screws (for mounting in wall studs)
  • 1/4-in x 3-in hanger bolts (for mounting in drywall)
  • 1/4-in x 2-1/2-in toggle-bolt wall anchors, pack of 2, #115648 (for mounting in drywall)
  • Valspar Signature: Indigo Cloth, #4009-7; Sea Kiss, #5005-9C; Coral Passion, #2001-1B; Mustand Glaze, #3006-3A

Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown. Availability varies by market for lumber species and sizes.

Missing anything? Shop Online

Instructions

Step 1

Determine the locations where you want to install the hangers and mark them on the wall with painter’s tape. Using an electronic stud finder, determine which ones are over a wall stud. Adjust the locations slightly to center the hanger over the stud as needed. Then mark any locations that will require a toggle-bolt drywall anchor.

Good to Know

For hangers not mounted in wall studs, avoid placing them closer than 16 inches together to prevent possible drywall damage.

Step 2

Use pliers to remove the existing hardware from a wooden leg or foot. In that hole, attach a dowel screw for hangers to be screwed into a wall stud, or add a hanger bolt for hangers to be screwed into a toggle-bolt wall anchor.

Step 3

Apply at least two coats of the paint of your choice and let dry overnight before using.

Step 4

Screw the hanger into the wall stud or drywall anchor. Repeat for the remaining hangers.

Step 5

Shelf bracket holders

For an alternative to wooden legs and feet, add carved shelf brackets (#225705, 163257).

Step 6

To complement your wall hangers and provide a safe place for wet shoes, partially fill a sealed water-heater pan (#317904) with pea gravel (#92130) and position it below the hangers.