Have you ever seen a still life that looked so real, you thought you could lift the objects right out of the painting? Then you'll appreciate this shelf project that lets you create your own composition of elements within a frame. Follow our instructions, and then gather an assortment of lightweight items. Have fun with color combinations of the items and the frame, in addition to the wall - try painting a block of color behind your frame for more impact.
General Instructions
Rough Cost Estimate: $35 for one frame (Does not include labor cost or applicable taxes, which vary by market.)
Rough Time Estimate: 1 week (for one small- to medium-size frame)
Base the size of your frame on the available wallspace. Determine a suitable dimension for the frame's height and width.
Note:You may need to make adjustments to the steps below and the materials purchased depending on your frame's size.
Step-by-Step
1. Using a miter saw, cut four pieces of moulding, mitering the ends to a 45-degree angle. If your moulding is thinner along one long side, miter so that the thinner edge will run along the inside of the frame. The vertical pieces should accommodate your height dimension from long point to long point. The horizontal pieces should be measured and cut similarly. Assemble the pieces, and check for square. Drive wire brads into the outer edges of the four corners to join the four pieces.
2. Cut two pieces of the square dowel measuring approximately 2 inches longer than the frame's short inside edges. Cut two more dowels approximately 3-1/2 inches longer than your long inside edges. Arrange the cut dowels into a rectangle on the back of the frame, per the photograph. For shelf support, at least one horizontal dowel should be flush with the inside edge of your frame. Glue the dowel pieces in place. When the glue is dry, turn over the frame and nail through the front into the dowels.
3. Cut the poplar scant to a length about 1/16 inch shorter than the width of the frame's opening. Measure 2 inches in from one long side of the poplar, and mark this measurement at both ends. At two corners, cut a 45-degree notch starting at the marks (refer to the photograph). Sand any rough edges. Place the shelf inside the frame's opening, resting it on a horizontal dowel. Nail through the top of the shelf into the dowel.
4. Fill all nail holes with wood filler, and sand smooth. Paint or stain the entire assembly the color of your choice. Then attach a picture hanger to the back of the frame, and affix felt bumpers to the two bottom corners.
Styles Defined
Cottage --This style, with a farmhouse feel, was inspired by a collection of speckled ceramic teapots. To coordinate with these, we picked a traditional moulding style and placed the crisp, white frame on a sunny yellow beaded-board wall.
Urban --To evoke an urban look, we selected sleek base moulding for the frames and painted both in a matte finish. Pictured above, this dramatic combination of red, black, and dark gray sets off the white modern-style vases.
Tools, products, materials, techniques, building codes and local regulations change; therefore, Lowe's assumes no liability for omissions, errors or the outcome of any project. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed professional if in doubt about any procedures. Please read our terms of use.