- Ideas & How-Tos
Choose Your Savings
Garbage disposals are an easy way to get rid of food waste in your kitchen. Installing a garbage disposer is a relatively easy project for an experienced do-it-yourselfer. All you need to get started are a few basic tools, some elbow grease and a little patience.
Use this checklist when you go to the store and purchase your items.
Before you begin your project, check with local authorities to see if a permit is required. It's also important to take a few safety precautions:
1. Wear goggles and a dust mask.
2. Turn off the power.
3. Test the wires to ensure the power is off.
4. Lock the panel box, so no one can accidentally turn the power back on while you're working.
5. Have your work checked by an inspector.
6. Consult a licensed electrician to avoid overloading the circuit.
Now you're ready to start the installation process.
If you have a two-bowl sink, remove the drain lines that connect the two bowls. Remove the strainer from the bowl to which you'll be attaching the disposer. Then remove the strainer body, which forms the rim to which the drain line was attached. Once complete, you'll be left with a simple hole in the bottom of the sink bowl.
Roll plumbers putty between your hands to form a snake, then run it around the base of the disposer flange included with the unit. Place the flange in the drain hole, seating it firmly.
Install the gasket and upper- and lower-mounting rings on the flange. Then, snap the retaining ring in place. Tighten the three screws on the lower-mounting ring until the flange is firmly seated. Most of the plumber's putty will have squeezed from around the top of the flange at this point. Trim the putty and clean the sink.
Attach the disposer unit to the flange according to the manufacturer's directions. (Some are attached using a mounting ring. Others are attached with bolts.)
Using the included washer or gasket, attach the discharge tube to the discharge opening in the side of the unit. If a dishwasher is to be attached to the unit, knock out the plug inside the dishwasher nipple with a screwdriver. Clamp the dishwasher discharge tube in place on the nipple.
Install the drain lines. If you have a two-bowl sink, both bowls can be routed through a single P-trap by running the discharge tube from the disposer to a T in the drain line above the trap.
Ideally, the disposer should have its own circuit. If this is impossible or impractical, and you already have a dishwasher in place, you may be able to tie into the dishwasher circuit.
The switch necessary to operate the unit is a simple single-pole switch. The white wires are tied together with an appropriate wirenut, as are the bare ground wires. The black wires are each attached to a terminal on the switch—the incoming wire is attached to the bottom terminal, and the wire which travels to the disposer unit, is attached to the top terminal.
If you're using an existing switched circuit, or if you've had an electrician install one for you, the electrical connections necessary to install the disposal are minimal. At the disposal, remove the plate that covers the electrical connections for the unit. Using an appropriate wirenut, connect the white wire from the disposer unit to the white wire from the switch. Do the same with the black wires, then connect the bare ground wire from the switch to the ground connector on the disposer. Replace the cover plate.
*Time and Cost are estimated.