Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Easy DIY Pencil Holder

Brought to you by Lowe's Creative Ideas

Keep pens and pencils handy and organized with this holder you can make in minutes for less than $5. Then keep it close to your desk or kitchen planning center.

Wooden pen and pencil holder

Project Overview

Skill Level

Beginner

Estimated Time

A few hours

Estimated Cost

$$$$$

Tools & Materials

Tools

  • Drill and bit set
  • Ruler
  • Pliers
  • Painter’s tape
  • 120-grit and 180-grit sandpaper

Materials

  • 8-in Parsons table leg, #605
  • Wood putty (optional)
  • Valspar Signature, Michigan Ave. (#ar1421)

Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown. Availability varies by market for lumber species and sizes.

Missing anything? Shop Online

Instructions

Step 1

Use pliers to remove the threaded mounting screw from the end of the leg. Fill the hole with wood putty and sand smooth if you plan to paint the holder.

Step 2

Draw a fine pencil line centered down the length of one face on the leg. Mark seven dots 1 inch apart and 1 inch from each end.

Step 3

Place tape flags 1 inch up from the tips of your drill bits, and drill 1-inch-deep holes to fit the sizes of the pencils and pens you’ll store. For example, most pencils fit in a 5/16-inch-diameter hole.

Good to Know

If your bits come in a case with individual holes of different sizes for each bit, you can tell what size holes your pens and pencils need by seeing how they fit different holes in the case. If it’s a snug fit, choose the next bit size up in diameter.

Step 4

Sand the holder and wipe clean. Then apply your choice of finishes.