Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
Create your own shade with this simple, sturdy beach tent - and enjoy the surf longer.
Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown. Availability varies by market for lumber species and sizes.
Missing anything? Shop Online
Drill a pilot hole in the end of each 6' pole and twist in the screw eye tightly.
Trim a 48" dowel to 40" using a handsaw. Use a hammer and an awl or a screw to pound a hole through the centers of two cup pulls and attach one to the end of the 40" dowel with a screw (drilling a pilot hole in the dowel using a 5/32" or other small drill bit keeps the dowel from splitting). The second cup pull will be added to the other side when you assemble the tent.
Paint the 6' poles and the dowel white.
Lay out the curtain panel and tape off seven red stripes. Each stripe should be about 3" wide; leave 3-1/8" of space between stripes.
Once the entire panel is taped off, carefully roll or brush on one coat of red paint.
Work lightly with the paint. If you roll the paint on too heavily or try hard to work it in, it may bleed onto the white stripes.
Once the curtain panel is dry, add 3/8" grommets to each corner, following the instructions in the grommet kit.
Screw the sand anchors into the sand or ground 40" apart, keeping them as level as possible. Insert the 6' poles and tighten the screws on the sand anchors to secure. Thread the 40" dowel through the eye screws on top of the poles to create a crossbar.
Add the remaining cup pull to the dowel end. This will create a secure upside-down U structure.
Drape the curtain over the crossbar. Thread the rope through the grommets on all four corners and tie to the spiral stakes. Twist the stakes into the sand and tighten the rope as needed to secure the tent structure.